DESCRIPTION
Overview
This Kalamera replacement door is specifically designed for 15-inch wine and beverage cooler models, featuring a stainless steel frame paired with double-layered tempered glass. It effectively blocks harmful UV rays, thereby protecting your wine collection from light damage, while the insulating layer between the glass panes helps maintain a constant internal temperature within the cabinet. This single door is suitable for 15-inch cooler units.
Width: 15 inches
Frame: Stainless steel
Glass: Dual-pane tempered glass with UV protection
Type: Single door for 15-inch models
Compatible Models
Fits KRC-90SS,KRC-30SZB,KRC-96BV-TGD,KRC-90BV
Installation Notes
Support the door securely during installation. Ensure proper alignment with all hinge points. Check the door seal for complete contact around the perimeter after installation. Adjust hinges if necessary to achieve a tight seal.
Important
Please verify your model is a 15-inch single door unit and appears on the compatibility list before ordering. Contact website@kalamera.com if you need help confirming the correct door for your specific model.
PARAMETER
Temperature Zones
Temperature Range
Capacity
Door Type
Configuration
Venting
Product Dimensions
Net Weight
Noise Level
Voltage
Input Power
INSTALLATION GUIDE
Installation Type
Built-in or freestanding — designed to fit your space.
Ventilation
- Built-in: Front-venting design requires no rear clearance. Also suitable for freestanding use
- Freestanding: Rear venting — allow adequate space behind the unit for airflow
Clearance
- Built-in models need no mandatory clearance for operation. Additional spacing recommended for easier installation and routine maintenance
- For built-in installation: leave at least 1/4" on each side and 1" behind for proper air circulation
Cutout & Cabinet Fit
- Follow the specified cutout dimensions to ensure smooth door swing and full shelf extension
- When installing between frameless cabinets, a 1/2" (12 mm) filler strip or side panel on the hinge side prevents door interference with adjacent cabinetry
Installation Steps
- Place the unit on a level surface and align with the specified cutout dimensions
- Verify alignment and spacing for smooth door operation and structural stability
- Connect to power
- Wait 24 hours before loading beverages to allow the refrigerant to fully settle
Important
- Do not tilt the unit more than 45° during transport
- Ensure the floor can support the unit's fully loaded weight